ARTEMIS 2 components
K2.0010433
折叠脚钢质C型灯架。
K2.0010489
artemis碳纤维伸缩中轴,直径1.8英寸,免工具夹具,无扭转导向1.5英寸内轴,有长度微调轴。
K2.0041474
Artemis carbon fibre telescopic centre post, ø1.8in, no-tool clamp, torsion-free guided ø1.5in inner post, fine trim adjustment. Length from 37cm / 14,56in to 46,5cm / 18,3...
K2.0041976
Modular center post extension to extent the 1.8in artemis center post by 21,6cm / 8.5in. ø1.8in, length 21,6cm / 8.5in Lemo 3B 16 pin NOTE Only for ARTEMIS 2 and TRINITY 2
KK.0041404
该超长主杆为标准1.8英寸粗,可以用来替换系统自带的标准长度主杆。 它可以极大的扩展artemis和TRINITY的高低范围,为运镜提供更多更丰富拍摄可能。 最大长度 1998mm / 6.55ft 最小长度: 1190mm / 3,9 ft 外杆直径 1.8in / 内杆直径 1.5in lemo 3b 16针 注意: 仅适用于ARTEMI...
KK.0038543
K2.0010569
将稳定器弯柄的长度延长35mm/1.37"。
K2.0014280
滚花手柄延长管在1.8英寸中轴上方增加了第2个滚花手柄。 在低机位模式时,利用该滚花手柄有利于更精确的操控。
K2.0042716
The improved monitor mount Gen.2 offers a larger distance between the rods, so that it can be fixed better and more compactly on the carriage or under table. The improved r...
K2.0042717
K2.0042710
K2.0042711
K0.0040291
利用这套垫圈在1.74" Volt中柱上安装1.8" artemis万向节。 K2.0040249 1x 底部垫圈,转1.8"万向节 K2.0040250 1x 顶部定心环,转1.8"万向节
K2.0039300
The Battery Mounting System generation 2, contains two key components: The Battery Mounting Base which is available as BMS-2 for Artemis and TRINITY generation 2, as also a...
K2.0040284
New modular and extremely flexible battery mounting system. The interchangeable battery holders can be changed quickly and easily. The electrical contact to the battery bod...
K0.0044358
K2.0040286