CCI adjustments after a Gel or HCI choice

Tue Jan 10, 2017 2:20 pm

I found a saturated yellow- Starraro 2003-
And I thought I'd pull some of the green out-
(Yellow is always tricky) :mrgreen:
So- do you know if there is a method where I could dial out some of the green?
I'd imagine I could simply tap into The CCI function and dial left but so far I can not seem to do that.
vitovittorio
 
Posts: 5
Joined: Mon Jan 09, 2017 9:20 pm

Re: CCI adjustments after a Gel or HCI choice

Wed Jan 11, 2017 1:45 am

Hello vitovittorio,

It is not possible to adjust gel colors in the SkyPanel. Once a gel color is selected, the color is not changeable. But this is a great idea!

Of course, you can create colors in other ways to get the exact color you are looking for. For example, you could use HSI mode, RGBW mode (via DMX) or xy Coordinate Mode (via DMX) and adjust the parameters to get a very specific color. There are countless color combinations to pick from in these modes.

I hope this helps and thanks for your post.

- Mike Wagner
Senior Product Manager, ARRI Lighting
Mike Wagner
 
Posts: 31
Joined: Mon Nov 23, 2015 8:42 pm

Re: CCI adjustments after a Gel or HCI choice

Wed Jan 11, 2017 5:16 am

Thank for your reply Mike.
vitovittorio
 
Posts: 5
Joined: Mon Jan 09, 2017 9:20 pm

Re: CCI adjustments after a Gel or HCI choice

Wed Jul 19, 2017 6:50 pm

Mike Said
"of course, you can create colors in other ways to get the exact color you are looking for. For example, you could use HSI mode, RGBW mode (via DMX) or xy Coordinate Mode (via DMX) and adjust the parameters to get a very specific color. There are countless color combinations to pick from in these modes."
Lets go back to The Starraro 2003 example-
Can I learn and determine the RGBW color percentages to a custom specific color, (Starraro 2003), and therefore enter those percentages under the RGBW mode as a starting point to begin to decrease the green?
vitovittorio
 
Posts: 5
Joined: Mon Jan 09, 2017 9:20 pm

Re: CCI adjustments after a Gel or HCI choice

Thu Jul 20, 2017 12:08 am

vitovittorio,

Yes, this is possible. On our website we have Gel Conversion charts that allows you to translate gel colors to HSI or RGBW values. Please visit this link:

https://www.arri.com/lighting/skypanel/products/s60_c/

And click on the downloads tab underneath the SkyPanel image. Here you find "ARRI SkyPanel - Gel Conversion Charts" under the Technical Information section.

I hope these are helpful. Thanks for your post.

- Mike Wagner
Mike Wagner
 
Posts: 31
Joined: Mon Nov 23, 2015 8:42 pm

Return to LED fixtures